headerpic
Home G3xDDC-CSVUserlistBrowser
Other versions
Useful stuff Deutsche Seiten
Preface External rigs G305/313/315
FDM-S2 version
HDSDR version Perseus version PowerSDR QtRadio version SDR# version SDRConsole SdrDx version SDRuno version Twente WebSDR First steps Download
ELAD FDM-S2 version of CSVUserlistBrowser
The version for the ELAD FDM-S2 uses the CAT interface of the ELAD software. For data exchange a virtual COM port pair of a so called COM port emulator is needed.
Brief instructions
  1. Download the WiNRADiO version of CSVUserlistBrowser and copy the files to a directory with permission to write to the file system.
  2. Rename the executable to "ELADFDM-CSVUserlistBrowser.exe". The WiNRADiO and SDR# plugins are not needed.
  3. If not yet done install a virtual COM port emulator. Please read the hints on the page Preface.
  4. In case you have not downloaded station lists with CSVUserlistBrowser before please follow the instructions on the page First steps.
  5. In the ELAD software under "Setup Advanced", "Remote control" specify one of the two COM ports of a virtual pair you have set up, e. g. COM12. Only the ELAD CAT mode "Slave" is supported. E. g. DRM can only be tuned in with RX1
  6. In ELADFDM-CSVUserlistBrowser.exe under "Options, Settings", "COM ports/TCP" specify its "partner", e. g. COM13. The baud rate normally is ignored but it's a good idea to select the same as in the ELAD setup. Click "Apply".
Now doubleclicking an entry in a list in ELADFDM-CSVUserlistBrowser should tune the corresponding frequency on the ELAD.
WARNING: Never use an Elad FDMSW2 CAT control on a VSPE splitter! Any of the applications controlling the Elad will fail sooner or later! Elad uses a YAESU CAT protocol which does not allow unique interpretation of the data responded. A combination of Omnirig and MaxDbSm will fail as a combination of Omnirig and ELADFDM-CSVUserlistBrowser will fail (and others). ELADFDM-CSVUserlistBrowser does its best to sort out the received data, but a stable coexistance is not guaranteed.
COM-Port
TCP version
Since version 1_107Beta of the Elad SW2 software remote controlling through a TCP server is also possible. A virtual COM port is no longer required.
Under Elad settings "Remote Ctrl" activate the TCP server on an address listed (the image shows just an example). In the settings of ELADFDM-CSVUserlistBrowser select the same IP address and enter the same port. Click the "T" button to check the connection. Then click "Apply COM port/TCP settings" ("Use TCP" must be chosen) and the control of Elad should now be done through the TCP server. This Elad interface has more capabilities and control is much more responsive than the CAT control through a virtual COM port.
TCP
ELAD
Page hits: 1868 visitors, 2153 robots